LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Mechanical - 4.6L - 1 Of 4) >> On-Vehicle Repair Instructions (1 Of 2) >> Positive Crankcase Ventilation Hose/Pipe/Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying PCV Foul Air Tube Quick Connect Fitting
    GM1661024Courtesy of GENERAL MOTORS CORP.
  1. If servicing the PCV foul air tube, perform the following steps, connect the PCV foul air tube quick connect fitting to the right camshaft cover. Refer to Plastic Collar Quick Connect Fitting Service .
  2. Connect the PCV foul air tube quick connect fitting at the intake manifold fitting. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Install the PCV foul air tube to the retaining features on the intake manifold.
  4. Fig 2: View Of Power Steering Pump
    GM1661040Courtesy of GENERAL MOTORS CORP.
  5. Install the power steering pump into position.
  6. NOTE: Refer to Fastener Notice .
  7. Install the power steering pump bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  8. Install the drive belt. Refer to Drive Belt Replacement .
  9. Fig 3: Identifying PCV Fresh Air Tube
    GM1661022Courtesy of GENERAL MOTORS CORP.
  10. If servicing the PCV fresh air tube, perform the following steps, route the PCV fresh air tube under the brake booster vacuum hose and EVAP purge solenoid.
  11. Connect the PCV fresh air tube quick connect fitting at the air cleaner outlet duct. Refer to Plastic Collar Quick Connect Fitting Service .
  12. Connect the PCV fresh air tube quick connect fitting at the left camshaft cover. Refer to Plastic Collar Quick Connect Fitting Service .
  13. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .