LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Mechanical - 4.6L - 1 Of 4) >> On-Vehicle Repair Instructions (1 Of 2) >> Oil Pump Outlet Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Outlet Tube O-Ring
    GM928363Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW O-ring on the oil outlet tube.
    2. Fig 2: View Of Oil Outlet Tube Bolts
    GM928361Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the oil outlet tube and bolts.

    Tighten:  Tighten the oil outlet tube bolts to 10 N.m (89 lb in).

    3. Fig 3: Identifying Primary Timing Gear Alignment Marks
    GM517185Courtesy of GENERAL MOTORS CORP.
  3. Ensure the primary timing marks (1) are aligned vertically.
  4. Install the primary drive chain tensioner. Refer to Primary Camshaft Drive Chain Tensioner Replacement .
  5. Install the secondary camshaft drive chains. Refer to Secondary Camshaft Drive Chain Replacement - Left Side  and Secondary Camshaft Drive Chain Replacement - Right Side .
  6. Install the oil pump. Refer to Oil Pump Replacement .
scientia non olet · About LEMON Manuals