LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Mechanical - 4.6L - 1 Of 4) >> On-Vehicle Repair Instructions (1 Of 2) >> Fuel Injector Sight Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Injector Sight Shield
    GM1661316Courtesy of GENERAL MOTORS CORP.
  1. Grasp the intake manifold sight shield cover at the left side, lift up in order to disengage the cover from the ball stud.
  2. Grasp the intake manifold sight shield cover at the right side, lift up in order to disengage the cover from the ball stud.
  3. Remove the intake manifold sight shield cover from under the tab on the secondary air injection (AIR) check valve bracket.
  4. Remove the intake manifold sight shield cover.
    5. Fig 2: Identifying Rear Intake Manifold Sight Shield
    GM1661329Courtesy of GENERAL MOTORS CORP.
  5. If necessary to remove the rear intake manifold sight shield perform the following steps, remove the AIR check valve. Refer to Secondary Air Injection Check Valve Replacement .
  6. Grasp the rear intake manifold sight shield cover and lift up in order to disengage the cover from the ball studs.
  7. Remove the rear intake manifold sight shield cover.
scientia non olet · About LEMON Manuals