LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Mechanical - 4.6L - 1 Of 4) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Mount Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Right Engine Mount
    GM1660844Courtesy of GENERAL MOTORS CORP.
  1. Install the right engine mount stud through the hole in the engine mount bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the right engine mount to engine mount bracket nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

  3. Install the frame. Refer to Frame Replacement - Front .
scientia non olet · About LEMON Manuals