LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Mechanical - 4.6L - 1 Of 4) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Lift Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Lift Bracket Studs
    GM1660885Courtesy of GENERAL MOTORS CORP.
  1. Position the engine lift bracket to the cylinder head.
    2. NOTE: Refer to Fastener Notice .
  2. Install the engine lift bracket studs.

    Tighten:  Tighten the studs to 50 N.m (37 lb ft).

    3. Fig 2: Identifying Engine Lift Bracket
    GM1660883Courtesy of GENERAL MOTORS CORP.
  3. Install the transaxle brace onto the lift bracket studs.
  4. Install the transaxle brace nuts until sung.
  5. Raise the vehicle.
  6. Install the transaxle brace bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  7. Lower the vehicle.
  8. Tighten the transaxle brace nuts.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals