LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Mechanical - 4.6L - 1 Of 4) >> On-Vehicle Repair Instructions (1 Of 2) >> Drive Belt Tensioner Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt Tensioner
    GM1660276Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the drive belt. Refer to Drive Belt Replacement .
  3. Remove the right engine mount strut. Refer to Engine Mount Strut Replacement - Right Side .
  4. Discharge the air conditioning (A/C) system. Refer to Refrigerant Recovery and Recharging .
  5. Disconnect the A/C compressor suction hose from the A/C evaporator hose. Discard seal and reposition hose.
  6. Remove the drive belt tensioner bolt.
  7. Remove the drive belt tensioner.
scientia non olet · About LEMON Manuals