LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Mechanical - 4.6L - 1 Of 4) >> On-Vehicle Repair Instructions (1 Of 2) >> Camshaft Cover Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removal of Camshaft Cover
    GM522725Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Be careful to prevent the exposed section of the camshaft cover seal from being damaged by the edge of the cylinder head casting.
  1. Install the camshaft cover seal as required.
  2. Install the camshaft cover.
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the camshaft cover bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Install the ignition coils. Refer to Ignition Coil Replacement - Bank 1 .
    5. Fig 2: Identifying PCV Foul Air Tube Quick Connect Fitting
    GM1661024Courtesy of GENERAL MOTORS CORP.
  5. Connect the PCV foul air tube quick connect fitting to the camshaft cover. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Install the AIR check valve. Refer to Secondary Air Injection Check Valve Replacement .
  7. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals