LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Power Door Lock System And Release Systems) >> Repair Instructions >> Door Striker Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Door Striker, Spacer & Bolts
    GM612196Courtesy of GENERAL MOTORS CORP.
    CAUTION: Striker alignment is crucial for proper operation of the door systems. Do not hit the striker with a hammer or force alignment in any other way. Failure to properly adjust striker will result in excessive door efforts or extensive damage to door system operation which could result in personal injury.
  1. Position the spacer (3) and striker (2) to the lock pillar with the narrow part of the striker facing outward.
  2. Install the striker fasteners (1).
  3. Align the door striker. Refer to Door Lock Striker Adjustment .
    4. NOTE: Refer to Fastener Notice .
  4. Tighten the 2 striker fasteners.

    Tighten:  Tighten the striker fasteners to 27 N.m (20 lb ft).

scientia non olet · About LEMON Manuals