LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Solenoid Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Starter Solenoid Cable Clips
    GM1669937Courtesy of GENERAL MOTORS CORP.
  1. Layout the starter solenoid cable on top of the engine.
  2. Install the starter solenoid cable clips (1) to the left camshaft cover.
    3. Fig 2: Identifying Generator Terminal & Starter Solenoid Cable Terminal
    GM1670187Courtesy of GENERAL MOTORS CORP.
  3. Install the starter solenoid cable terminal (3) to the generator.
    4. NOTE: Refer to Fastener Notice .
  4. Install the generator terminal nut (2).

    Tighten:  Tighten the nut to 12 N.m (106 lb in).

  5. Position the starter solenoid cable protective boot (1) at the generator.
    6. Fig 3: Identifying "BAT" & "S" Terminals On Starter
    GM1669932Courtesy of GENERAL MOTORS CORP.
  6. Install the starter solenoid cable to the starter.
  7. Install the "S" terminal nut (2) to the starter.

    Tighten:  Tighten the nut to 4 N.m (35 lb in).

  8. Install the "BAT" terminal nut (1) to the starter.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

    9. Fig 4: Identifying Starter Solenoid Cable To Bussed Electrical Center
    GM1663997Courtesy of GENERAL MOTORS CORP.
  9. Install the starter solenoid cable to the BEC stud.
  10. Install the nut (1) securing the starter solenoid cable to the BEC.

    Tighten:  Tighten the nut to 15 N.m (11 lb ft).

    11. Fig 5: View Of Junction Block Cover
    GM1664482Courtesy of GENERAL MOTORS CORP.
  11. Install the junction block cover.
  12. Install the intake manifold. Refer to Intake Manifold Replacement .
    13. Fig 6: Identifying Engine Harness Electrical Connectors
    GM1665457Courtesy of GENERAL MOTORS CORP.
  13. Connect the engine harness electrical connectors (1) to the starter solenoid cable electrical connectors.
  14. Install the front compartment sight shield. Refer to Front Compartment Sight Shields Replacement .
  15. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals