LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Starter
    GM1669939Courtesy of GENERAL MOTORS CORP.
  1. Install the starter motor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the starter motor bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    3. Fig 2: Identifying "BAT" & "S" Terminals On Starter
    GM1669932Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the large terminal locator tab is placed into the starter solenoid retention slot.
  3. Install the starter solenoid cable to the starter.
  4. Install the "S" terminal nut (2) to the starter.

    Tighten:  Tighten the nut to 4 N.m (35 lb in).

  5. Install the "BAT" terminal nut (1) to the starter.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  6. Install the intake manifold. Refer to Intake Manifold Replacement .
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals