LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> DTC P0562 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

With the scan tool installed, ignition ON and the engine OFF, observe the Ignition 1 Signal parameter in the ECM data list. The Ignition 1 Signal parameter should read 10.5 volts or greater.

scientia non olet · About LEMON Manuals