LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> DTC P0562 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the voltage at the battery terminals and compare it with the Ignition 1 Signal parameter in the ECM data list. Verify that battery and Ignition 1 signal readings do not differ more than 1.0 volts.
    • If greater than 1.0 volts test the Ignition 1, ground circuits of the ECM for high resistance or replace the ECM.
  2. Refer to Charging System Test .
scientia non olet · About LEMON Manuals