Removal Procedure
WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the headliner. Refer to Headlining Trim Panel Replacement .
- Starting in one corner of the cardboard, pulling downward, cut the adhesive beads using a sharp putty knife or equivalent.
- Cut off all of the adhesive beads.
- Remove the cardboard roof insulator.
CAUTION:
Do not attempt to repair or alter the head impact energy-absorbing material glued to the headliner or to the garnish trims. If the material is damaged, replace the headliner and/or the garnish trim. Failure to do so could result in personal injury.
NOTE:
Use care when removing the cardboard roof insulator. Excessive pressure can cause dents in the roof panel.