LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Floor Coverings & Headliners) >> Repair Instructions >> Cardboard Insulator Headliner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT:
    • Installation of a new cardboard roof insulator is necessary to ensure the structural integrity of the roof system. Use GM P/N 12378192 Adhesive available through General Motors Service Parts Operations.
    • The cardboard roof insulator must be installed within five minutes of adhesive application.
    Fig 1: Identifying Specified Height & Width Of Adhesive
    GM107685Courtesy of GENERAL MOTORS CORP.
  1. Apply beads of adhesive to a height (2) of 6-9 mm (1/4-3/8 in) and a width 1) of 15 mm (5/8 in).
    2. Fig 2: Applying Adhesive To Locations Marked On Cardboard Insulator
    GM107686Courtesy of GENERAL MOTORS CORP.
  2. Apply the adhesive (1) in the locations marked on the cardboard insulator.
    3. Fig 3: View Of Cardboard Roof Insulator
    GM474278Courtesy of GENERAL MOTORS CORP.
  3. Place the cardboard roof insulator to the roof panel.
    4. IMPORTANT: Gluing the headliner to the cardboard roof insulator during installation is not required.
  4. Install the headliner. Refer to Headlining Trim Panel Replacement .
scientia non olet · About LEMON Manuals