LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Frame And Underbody) >> Repair Instructions >> Frame Cushion or Insulator Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Clamp J-45725 Onto The Bushing
    GM1361419Courtesy of GENERAL MOTORS CORP.
  1. Install clamp J-45725  onto the bushing leaving about an 1/8 inch from the bottom of the bushing. See Special Tools .
    2. Fig 2: Aligning Split Of Bushing
    GM1361422Courtesy of GENERAL MOTORS CORP.
  2. Align the split of the bushing to the front of the frame.
    3. Fig 3: Using J-45725 To Install The Bushing
    GM1361424Courtesy of GENERAL MOTORS CORP.
  3. Using J-45725  install the bushing until the entire radius of the bushing is halfway recessed in the cradle. See Special Tools .
    4. Fig 4: Removing Clamp
    GM1361426Courtesy of GENERAL MOTORS CORP.
  4. Remove the J-45725  clamp. See Special Tools .
    5. Fig 5: Using J-45725 To Seat Lip Of The Bushing To The Bottom Of The Cradle Assembly
    GM1361427Courtesy of GENERAL MOTORS CORP.
  5. Using J-45725  install the bushing until the lip of the bushing is fully seated to the bottom of the cradle assembly. See Special Tools .
  6. Install the frame. Refer to Frame Replacement - Front .
scientia non olet · About LEMON Manuals