LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Compartment Lid Hinge Torque Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When a rear compartment lid hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
Fig 1: Identifying Torque Rod Adjuster
GM333514Courtesy of GENERAL MOTORS CORP.
  1. Support the rear compartment lid in the fully up position.
  2. Remove the rear compartment front trim panel. Refer to Rear Compartment Front Trim Panel Replacement .
  3. Use the J 41358-A  in order to disconnect the torque rod from the rear compartment lid hinge.
scientia non olet · About LEMON Manuals