Installation Procedure
WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
- Install the upper hood assist rod ball stud (2) to the hood (1).
Tighten: Tighten the upper hood assist rod ball stud (2) to 9 N.m (80 lb in).
- Press the hood assist rod onto the upper hood assist rod ball stud (2).
- Ensure that the clip is fully seated on the hood assist rod.
- Install the lower hood assist rod ball stud (1) to the fender (2).
Tighten: Tighten the lower hood assist rod ball stud (1) to 24 N.m (18 lb ft).
- Press the hood assist rod onto the lower hood assist rod ball stud (1).
- Ensure that the clip is fully seated on the hood assist rod.
- Close the hood.