LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Open Assist Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
  1. Open and support the hood.
    2. Fig 1: View Of Hood Assist Rod & Components
    GM130511Courtesy of GENERAL MOTORS CORP.
  2. Release the clip retaining the hood assist rod (4) to the lower assist rod ball stud (3).
    NOTE: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.
  3. Release the clip retaining the hood assist rod (4) to the upper assist rod ball stud (1).
  4. Remove the hood assist rod (4) from the vehicle.
scientia non olet · About LEMON Manuals