LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Latch Release Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Remove the hood latch. Refer to Hood Latch Replacement .
    3. Fig 1: View Of Hood Latch & Release Cable
    GM457383Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the hood release cable (1) from the hood latch (2).
  4. Tie a piece of string around the hood release cable. This will ease the installation of the hood release cable through the engine compartment.
  5. Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
    6. Fig 2: View Of Hood Release Cable Clips
    GM457386Courtesy of GENERAL MOTORS CORP.
  6. Open the clips (1) retaining the hood release cable to the vehicle.
    7. Fig 3: View Of Hood Release Handle & Fasteners
    GM130468Courtesy of GENERAL MOTORS CORP.
  7. Remove the fasteners (2) securing the hood release handle (1) to the vehicle.
  8. Disconnect the hood release cable from the hood release handle (1).
  9. Tie a piece of string around the hood release cable. This will ease the installation of the hood release cable through the passenger compartment.
    10. Fig 4: View Of Hood Release Cable Grommet
    GM130471Courtesy of GENERAL MOTORS CORP.
  10. Remove the hood release cable grommet (2) from the wheel opening.
  11. Remove the hood release cable from the vehicle.
scientia non olet · About LEMON Manuals