LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Windshield Side Reveal Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Reveal Molding
    GM1644013Courtesy of GENERAL MOTORS CORP.
  1. Insert the reveal molding (3) to the pillar.
    2. NOTE: Refer to Fastener Notice .
  2. Install the screws (2) to the reveal molding (3).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  3. Tuck the rubber extension under the fender.
  4. Install the weatherstrip (1) to the windshield pillar flange.
scientia non olet · About LEMON Manuals