LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Steering Wheel & Steering Column) >> Diagnostic Information and Procedures >> Steering Column Tilt/Telescoping Inoperative >> Component Testing >> Tilt/Telescoping Actuator

Tilt/Telescoping Actuator

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector C1 at the appropriate tile/telescoping actuator.
  2. Test for less than 2.0 ohms of resistance between the control terminal A and the control terminal B.
    • If greater than the specified range, replace the appropriate tilt/telescoping actuator.
scientia non olet · About LEMON Manuals