Circuit/System Verification

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Ignition ON, view the scan tool Telescope Forward Switch parameter while cycling the tilt/telescope switch between the neutral and TELESCOPE IN position. The parameter should change between Active and Inactive.
- If any of the parameters do not cycle between the specified values, refer to Tilt/Telescope Sensor Circuit Malfunction
Observe the scan tool Tilt Sensor and Telescope Sensor parameters. Both reading should be between 0.2 and 4.8 volts.
- If not within the specified range, refer to Tilt/Telescope Sensor Circuit Malfunction .
Command the column to tilt up and down and telescope in and out using the tilt/telescope switch. The column should move in the commanded direction.
- If the column does not operate as specified, refer to Tilt/Telescope Actuator Circuit Malfunction