LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Steering Wheel & Steering Column) >> Diagnostic Information and Procedures >> DTC B2880 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Tilt Actuator

  1. Ignition OFF, disconnect the harness connector C1 at the telescoping actuator.
  2. Test for less than 2.0 ohms of resistance between the control terminal A and the control terminal B.
    • If greater than the specified range, replace the telescoping actuator.
scientia non olet · About LEMON Manuals