Entry/Exit Personalization

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

The SCM stores personalization information. The driver information center (DIC) is used to enable and disable the personalization feature in the SCM. A Class 2 message is sent to the SCM, by the DIC, which specifies that the SCM enable the personalization feature until disabled again using the DIC.

The steering column control module can store 6 possible positions: 3 entry positions and 3 exit positions.

Driver 1 exit position, set using the memory switches
Driver 2 exit position, set using the memory switches
Default exit position which is all forward, all up, with no memory position set
Driver 1 entry position, set using the memory switches
Driver 2 entry position, set using the memory switches
Last known driver entry position which is when the ignition is turned ON by an unknown driver