LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Front Fender Replacement >> Removal Procedure

Removal Procedure

    NOTE: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.
  1. Apply protective tape to the front edge of the front door and the rear edge of the front bumper fascia.
  2. Remove the wheelhouse panel. Refer to Front Wheelhouse Liner Replacement .
    3. Fig 1: View Of Side Hood Bumper
    GM742125Courtesy of GENERAL MOTORS CORP.
  3. Remove the side hood bumper from the vehicle.
    4. Fig 2: View Of Fender & Fender Reinforcement
    GM1386197Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolt that retains the fender reinforcement (2) and the fender (1) to the vehicle.
  5. Remove the fender reinforcement (2).
    6. Fig 3: View Of Front Fender
    GM1313670Courtesy of GENERAL MOTORS CORP.
  6. Remove the remaining bolts that retain the fender to the vehicle.
  7. Remove the fender from the vehicle.
scientia non olet · About LEMON Manuals