LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Repair Instructions >> Instrument Cluster Replacement >> Removal Procedure

Removal Procedure

  1. Remove the instrument panel cluster (IPC) bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
    2. Fig 1: View Of IPC Retaining Screws
    GM1340551Courtesy of GENERAL MOTORS CORP.
  2. Remove the screws retaining the IPC to the instrument panel (I/P).
    3. Fig 2: View Of CPA Arm & IPC Electrical Connector
    GM1300433Courtesy of GENERAL MOTORS CORP.
  3. Partially remove the IPC to reveal the electrical connector (2).
  4. Notice the position of the connector position assurance (CPA) arm (1).
    5. Fig 3: View Of IPC Electrical Connector
    GM1300436Courtesy of GENERAL MOTORS CORP.
  5. Move the CPA arm away from the electrical harness.
  6. Disconnect the electrical connector.
  7. Remove the IPC from the vehicle.
scientia non olet · About LEMON Manuals