LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2) >> Repair Instructions >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of VSS, Bolt & O-Ring Seal
    GM481937Courtesy of GENERAL MOTORS CORP.
  1. Install the O-ring seal (3) on the vehicle speed sensor (1).
  2. Coat the O-ring seal (3) with a thin film of transmission fluid.
  3. Install the vehicle speed sensor (1) into the transmission case.
    4. NOTE: Refer to Fastener Notice .
  4. Install the bolt (2).

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  5. Connect the wiring harness electrical connector to the vehicle speed sensor.
  6. Lower the vehicle.
  7. Refill the fluid as required.
scientia non olet · About LEMON Manuals