LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Extension Housing Rear Oil Seal Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Case Extension Housing Rear Oil Seal
    GM647512Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the inside diameter of the new seal with J 36850  .
  2. Use the J 21426  with a soft faced mallet to install the seal.
  3. Install the seal to the extension housing.
  4. Install the rear propeller shaft. Refer to Propeller Shaft Replacement - One Piece or Propeller Shaft Replacement - Two Piece .
  5. Remove the drain pan and lower the vehicle.
  6. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to Transmission Fluid Checking .
scientia non olet · About LEMON Manuals