LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Extension Housing Assembly Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Case Extension, Bolts & O-Ring Seal
    GM656358Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the transmission with a transmission jack.
  3. Place a drain pan under the vehicle.
  4. Remove the rear propeller shaft. Refer to Propeller Shaft Replacement - One Piece or Propeller Shaft Replacement - Two Piece .
  5. Remove the transmission mount. Refer to Transmission Mount Replacement .
  6. Remove the case extension bolts (1).
  7. Remove the case extension (2).
  8. Remove and discard the case extension O-ring seal (3).
scientia non olet · About LEMON Manuals