LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2) >> Repair Instructions >> Repair Instructions - On Vehicle >> Torque Converter Clutch/Cruise Control Release Switch Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Cruise Release Switch
    GM1302096Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector from the torque converter clutch/cruise control release switch.
  2. Complete the following in order to remove the torque converter clutch/cruise control release switch from the brake pedal bracket:
    1. Rotate the switch counter clockwise.
    2. Pull the switch from the retainer.
    3. Push the locking tabs inward to release the retainer.
scientia non olet · About LEMON Manuals