LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2) >> Repair Instructions >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Cable Grommet & Floor Panel
    GM1302083Courtesy of GENERAL MOTORS CORP.
  1. Push the range selector cable down through the floor panel (2) and seat the cable grommet (1).
    2. Fig 2: Locating Range Selector Cable Retainer At Lower Dash Panel
    GM1302084Courtesy of GENERAL MOTORS CORP.
  2. Route the range selector cable through the dash mat.
  3. Connect the range selector cable retainer (2) to the lower dash panel (1).
    4. Fig 3: View Of Range Selector Cable & Steering Column Bracket
    GM1302085Courtesy of GENERAL MOTORS CORP.
  4. Install the range selector cable (4) to the steering column bracket (5).
  5. Install the retainer (3) to the range selector cable (4).
  6. Push the range selector cable end (2) onto the range selector lever ball stud (1) to secure.
  7. Reposition the drivers side carpet to the floor panel.
  8. Inspect below the accelerator pedal for binding, to ensure full range of motion.
  9. Install the left hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Left Side .
  10. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    11. Fig 4: View Of Range Selector Cable & Components
    GM1302081Courtesy of GENERAL MOTORS CORP.
  11. Install the range selector cable (3) to the bracket (2).
  12. Install the retainer (4) to the range selector cable (3).
  13. Remove and discard the primary lock lockout pin if a new cable is being installed.
  14. Adjust the automatic transmission range selector cable. Refer to Range Selector Lever Cable Adjustment .
  15. Lower the vehicle.
scientia non olet · About LEMON Manuals