Tools Required

J 21368  Pump Body and Cover Alignment Band. See Special Tools .

Fig 1: View Of Oil Pump Cover & Oil Pump Body
Courtesy of GENERAL MOTORS CORP.
1. Place the oil pump cover onto the oil pump body and put stator shaft through a hole in the bench.
2. Install the pump cover bolts (233) finger tight only.
Fig 2: Identifying Pump Cover Bolts
Courtesy of GENERAL MOTORS CORP.
3. Install the J 21368  . See Special Tools .
NOTE: Refer to Fastener Notice .
4. Tighten the pump cover bolts (233).

   Tighten:  Tighten the bolts to 24 N.m (18 lb ft).

5. Remove the J 21368  . See Special Tools .