LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Input Carrier Inspection

Input Carrier Inspection

    Fig 1: Identifying Input Carrier Pinion End Play Measurements
    GM735074Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Check end play on each pinion. Clearance is the same for 4 or 5 pinion design.
  1. Check the input carrier pinion end play. The end play must not exceed 0.61 mm (0.024 in).
  2. Inspect the input carrier for pinion gear damage, proper pin stake and keystoned pinion gears. Pinions must rotate freely.
scientia non olet · About LEMON Manuals