LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Actuator Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Clutch Actuator Cylinder
    GM1302141Courtesy of GENERAL MOTORS CORP.
  1. Position the clutch actuator cylinder (1) to the input shaft bearing retainer (2).
    2. NOTE: Refer to Fastener Notice .
  2. Install the 2 clutch actuator cylinder bolts (3).

    Tighten:  Tighten the clutch actuator cylinder bolts to 8 N.m (71 lb in).

  3. Install the transmission. Refer to Transmission Replacement (4WD) or Transmission Replacement (RWD) .
scientia non olet · About LEMON Manuals