LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - AISIN Ar5) >> Repair Instructions >> Transmission Replacement (4WD) >> Transmission Final Test and Inspection

Transmission Final Test and Inspection

WARNING: This page is about a different variant/trim than selected.

Complete the following procedure after the transmission is installed in the vehicle:

  1. With the ignition OFF or disconnected and clutch pedal depressed, crank the engine several times. Listen for any unusual noises or evidence that any parts are binding.
  2. Place the transmission in neutral, start the engine and listen for any unusual noises or evidence that any parts are binding.
  3. Turn OFF the ignition.
  4. Perform a final inspection for the proper fluid level. Refer to Transmission Fluid Replacement .
  5. Road test the vehicle.
scientia non olet · About LEMON Manuals