LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - AISIN Ar5) >> Repair Instructions >> Transmission Housing Oil Seal Replacement - Rear (4WD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Output Shaft Seal - 4WD
    GM881168Courtesy of GENERAL MOTORS CORP.
  1. Using the J 45867  and a hammer, install the NEW rear transmission housing oil seal. See Special Tools .
  2. Check the transmission fluid level. Add if necessary. Refer to Transmission Fluid Replacement .
  3. Install the transfer case assembly. Refer to Transfer Case Assembly Replacement .
scientia non olet · About LEMON Manuals