LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - AISIN Ar5) >> Repair Instructions >> Shift Lever Assembly Replacement (W/O D06) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Shift Lever & Set Screw
    GM1397260Courtesy of GENERAL MOTORS CORP.
  1. Install the shift lever assembly to the control lever, aligning the set screw threaded hole with the seat (3)
  2. Apply threadlock GM P/N 12345493 (Canadian P/N 10953488) to the shift lever set screw threads.
    3. NOTE: Refer to Fastener Notice .
  3. Install the shift lever set screw.

    Tighten:  Tighten the shift lever set screw to 25 N.m (18 lb ft).

    4. Fig 2: View Of Boot & Retainers (W/O D06)
    GM1397263Courtesy of GENERAL MOTORS CORP.
  4. Position the boot tabs (4) under the rear of the console opening.
  5. Push downward on the front of the boot (3) in order to engage the boot retainers (2) with the floor console (1).
scientia non olet · About LEMON Manuals