Shift Control Housing Cleaning and Inspection
WARNING: This page is about a different variant/trim than selected.
- Inspect the shift boots and seals for cuts or tears.
- Replace any faulty shift boot or seal.
- Inspect the shift control lever for the following conditions:
- Cracked or damaged bushing
- Cracked or damaged spring seat
- Worn swivel pins
- Damaged threads
- Bent or cracked lever
- Replace the shift control lever assembly if any of the above conditions are found.
- Inspect the shift control housing for the following conditions:
- Worn or damaged shift control lever plungers
- Missing or damaged shift control lever shaft springs
- Worn spring seat surface
- Replace the shift control housing as an assembly if any of the above conditions are found.