LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transaxle - 4T80-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Case Extension and Scavenge Pipe Removal

Case Extension and Scavenge Pipe Removal

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Case Extension Components
    GM11839Courtesy of GENERAL MOTORS CORP.
  1. Remove the following parts from the case extension:
    • Five 13-mm bolts (128, 129)
    • One 15-mm stud (127)
  2. Remove the case extension (134) and the seal (126).
  3. Remove the roller thrust bearing (132) and the selective washer (133)
    4. Fig 2: Identifying Scavenge Tube & Seals
    GM11840Courtesy of GENERAL MOTORS CORP.
  4. Remove the 8-mm scavenge tube bolt (15).
  5. Remove the scavenge tube (54) by prying on the differential.
  6. Remove the scavenge tube seal (53).
scientia non olet · About LEMON Manuals