Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Remove the plug from the inlet port of the brake caliper, if necessary.

Fig 1: Brake Hose To Caliper View

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Install NEW copper brake hose gaskets.

Assemble the brake hose bolt and the NEW copper brake hose gaskets to the brake hose.

NOTE: Refer to Fastener Notice .

Install the brake hose bolt to the brake caliper.
Tighten:
- Tighten the brake hose to caliper bolt to 40 N.m (30 lb ft) (JL9).
- Tighten the brake hose to caliper bolt to 45 N.m (33 lb ft) (J55).

Fig 2: Removing/Installing Brake Hose From Brake Hose Bracket

Courtesy of GENERAL MOTORS CORP.

NOTE: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.

Install the brake hose to the brake hose bracket.
Install the brake hose retainer to the brake hose.

Fig 3: Removing/Installing Rear Brake Hose

Courtesy of GENERAL MOTORS CORP.

Remove the cap from the brake pipe fitting end.
Install the brake pipe fitting to the brake hose.
Tighten: Tighten the brake pipe fitting to 15 N.m (11 lb ft).

CAUTION: Do not move the vehicle until a firm brake pedal is obtained. Air in the brake system can cause the loss of brakes with possible personal injury.

Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.