LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Power Seat System) >> Diagnostic Information and Procedures >> DTC B1735, B1740, B1745, B1750, B1755, B1760, B1815, B1820, B1830, B1835, B1840, B1845, B2085, or B2090 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the appropriate seat or lumbar adjuster switch.
  2. Test for infinite resistance between each seat direction signal terminal and the switch B+ terminal with the switch in the open position.
    • If less than infinite resistance, replace the switch.
  3. Test for less than 1 ohm of resistance between each seat direction signal terminal and the B+ terminal with the switch in the closed position.
    • If greater than 1 ohm, replace the switch.
scientia non olet · About LEMON Manuals