LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Exhaust System) >> Repair Instructions >> Oxygen Sensor Wiring Harness Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Oxygen Sensor Wiring Harness Heat Shield
GM1670491Courtesy of GENERAL MOTORS CORP.
  1. Raise the heat shield until the HO2S clips can be connected.
  2. Connect the HO2S clips to the heat shield.
  3. Position the heat shield to the floor panel.
  4. Using a rivet gun, install the rivets.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals