LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement (5.3L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Mount
    GM1293472Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission mount.
    2. Fig 2: View Of Transmission Mount Bolts
    GM1293735Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the bolts (1, 2) securing the transmission mount to the transmission.

    Tighten:  Tighten the bolts to 65 N.m (48 lb ft).

    3. Fig 3: View Of Transmission Crossmember Support
    GM752134Courtesy of GENERAL MOTORS CORP.
  3. Install the transmission support to the vehicle. Refer to Transmission Support Replacement .
    4. Fig 4: View Of Transmission Mount To Transmission Support
    GM744176Courtesy of GENERAL MOTORS CORP.
  4. Remove the transmission jack.
  5. Install the nuts securing the transmission mount to the transmission support.

    Tighten:  Tighten the nuts to 46 N.m (35 lb ft).

  6. Lower the vehicle.
scientia non olet · About LEMON Manuals