LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement (4.2L) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Mount To Transmission Support
    GM744176Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the transmission with a suitable jack.
  3. Remove the nuts securing the transmission mount to the transmission support.
    4. Fig 2: View Of Transmission Crossmember Support
    GM752134Courtesy of GENERAL MOTORS CORP.
  4. Remove the transmission support from the vehicle. Refer to Transmission Support Replacement .
    5. Fig 3: View Of Transmission Mount Bolts
    GM745754Courtesy of GENERAL MOTORS CORP.
  5. Remove the transmission mount bolts (1, 2).
    6. Fig 4: View Of Transmission Mount To Exhaust Hanger Mounting Bolts
    GM1334965Courtesy of GENERAL MOTORS CORP.
  6. Remove the transmission mount to the exhaust hanger mounting bolt.
  7. Separate the transmission mount from the exhaust hanger.
  8. Remove the transmission mount.
scientia non olet · About LEMON Manuals