LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Fluid Filler Tube & Seal Replacement (LM4) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator Tube & Seal
    GM396798Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW seal to the indicator tube.
  2. Install the oil level indicator tube.
    3. Fig 2: View Of Oil Level Indicator Tube Nut
    GM396797Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the indicator tube nut.

    Tighten:  Tighten the nut to 18 N.m (13 lb ft).

  4. Install the catalytic converter. Refer to Catalytic Converter Replacement (LL8) or Catalytic Converter Replacement (LH6/LS2) .
  5. Install the transmission crossmember. Refer to Transmission Support Replacement .
  6. Remove the support from the transmission.
  7. Lower the vehicle.
  8. Install the transmission oil level indicator.
  9. Fill the transmission to the proper level with DEXRON® VI transmission fluid. Refer to Transmission Fluid Check .
scientia non olet · About LEMON Manuals