LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Control Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Control & Bolts
    GM745783Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the transmission control.
  2. Install the transmission control bolts.

    Tighten:  Tighten the transmission control bolts to 25 N.m (18 lb ft).

    3. Fig 2: View Of Shift Control Cable & Shifter
    GM744173Courtesy of GENERAL MOTORS CORP.
  3. Install the range selector cable (2) to the floor shift control.
  4. Install the end of the range selector cable (1) to the transmission control ball stud.
  5. Connect the shift lock control solenoid wiring harness.
    6. Fig 3: View Of Center Console Assembly
    GM1234306Courtesy of GENERAL MOTORS CORP.
  6. Install the front floor console. Refer to Console Replacement .
  7. Check for proper operation of the floor shift control.
  8. Adjust the range selector cable if necessary. Refer to Range Selector Lever Cable Adjustment .
scientia non olet · About LEMON Manuals