Removal Procedure
WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure that the vehicle is in the park position.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the end of the range selector cable from the transmission range selector lever ball stud (6).
- Remove the retainer (5) from the range selector cable.
- Remove the range selector cable (4) from the bracket (1).
- Remove the cable from the retainer (3) on the floor panel. If the vehicle is equipped with 4WD, remove the cable from the retainers located on the transfer case.
- Push the cable grommet (2) up through the floor panel.
- Lower the vehicle.
- Remove the console. Refer to Console Replacement .
- Remove the drivers side front mat and carpet. Refer to Front Floor Panel Carpet Replacement .
- Remove the end of the range selector cable (1) from the floor control ball stud.
- Remove the range selector cable (2) from the floor shift control assembly.
- Remove the tape and grommet on the shift cable from the floor panel.
- Remove the range selector cable (3) from the vehicle.