Installation Procedure
WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install new seals on the servo pistons and the servo cover.
- Install the 2-4 servo assembly into the transmission.
- Install the J 29714-A . See Special Tools .
- Tighten the bolt in order to compress the servo cover.
- Install the servo cover retaining ring.
- Remove the J 29714-A from the oil pan flange. See Special Tools .
- Install the transmission oil pan bolt.
Tighten: Tighten the bolt to 11 N.m (97 lb in).
- Install the heat shield if equipped. Refer to Transmission Heat Shield Replacement .
- Install the exhaust pipe assembly. Refer to Catalytic Converter Replacement (LL8) or Catalytic Converter Replacement (LH6/LS2) .
- Install the transmission support. Refer to Transmission Support Replacement .
- Remove the transmission jack.
- Lower the vehicle.
- Fill the transmission to the proper level with DEXRON® VI transmission fluid. Refer to Transmission Fluid Check .
- Reset the TAP values. Refer to Transmission Adaptive Functions (TCM) .
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.