LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Manual Detent Spring Installation

Manual Detent Spring Installation

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Manual Detent Spring Assembly
    GM13263Courtesy of GENERAL MOTORS CORP.
  1. Inspect the manual detent spring assembly (63) for cracks or damage.
  2. Install the manual detent spring assembly (63).
    3. NOTE: Refer to Fastener Notice .
  3. Install the manual detent spring bolt (64).

    Tighten:  Tighten the bolt to 20-27 N.m (15-20 lb ft).

scientia non olet · About LEMON Manuals