LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Internal Transmission Speed Sensor Rotor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Output Shaft Seal & Output Shaft Sleeve
    GM5470Courtesy of GENERAL MOTORS CORP.
  1. Inspect the internal transmission speed sensor rotor (699) for cracks or damaged teeth.
  2. Inspect all splines on the output shaft (687) for cracks or damaged splines.
  3. Remove the output shaft seal (691) and the output shaft sleeve (690) (model dependent) 2WD units only.
    4. Fig 2: Using J 8433 & J 21427-01 To Remove Internal Speed Sensor Rotor
    GM5471Courtesy of GENERAL MOTORS CORP.
  4. If the internal speed sensor rotor (699) is damaged, replace it.
  5. Using J 8433  with J 21427-01  , remove the internal speed sensor rotor (699) from the output shaft (687). See Special Tools .
scientia non olet · About LEMON Manuals